50-0143 - Rigid Rear Fender Assembled

Rigid rear fender features relief over skirts to accept stainless fender trim attached by clips.
Fender is 7-1/2 wide with 3/4 wide brackets. It is fully assembled and riveted together with hinge and is drilled for the U-clamps. Fender is not equipped with a tail lamp hole.Before finishing with primer or paint installer must prepare fender by checking alignment of fender tail and bracket. All hinged fenders must be hand fitted at hinge and pin area prior to primer or paint. Alignment will have to be adjusted and tweaked to fit your components. Fender tail is not drilled or cut out for tail lamp installation. *NOTE: Optimal updated hing is availble for restorers who would like to replace hinge on our fenders. We suggest pre-fitting fender prior to painting. *NOTE: Chain panel on left side is par of fender non-removeable. *Note: UPS may consider this part as packaged oversize for shipment as compared to the actual weight which will result in higher shipping costs.

Fits:
EL 1939-1952
FL 1941-1954

UOM: EA
Country Of Origin: TAIWAN
OEM Cross Reference: 59604-39,59604-39
Suggested Items: 50-1243 - Replica Rigid Rear Fender Hinge Raw

Accessory Items:
31-0457 - Rear Fender Mount U-Clamps Parkerized
37-9204 - Replica Upper Fender Clamp Bolt Set
50-0360 - Rigid Rear Fender Assembled
50-0363 - Raw Rigid Rear Fender Assembly

Tech Notes: Suggested to use with #50-0913 Rear Fender Trim Set. *NOTE: We have an updated rear hinge available to replace existing hinge. Must be riveted in place #50-1243 Replica Rigid Rear Fender Hinge.