50-0142 - Rigid Rear Fender Assembled

Rigid rear fender features a cutout for the chain relief as on 1951-57 rigid models. Fender comes with a 7/8 inch wide bracket and does not have a tail lamp hole. Tail lamp hole may be cut as required. Before finishing with primer or paint installer must prepare fender by checking alignment of fender tail and bracket. All hinged fenders must be hand fitted at the hinge and pin area. Alignment will have to be adjusted and tweaked to fit your components. Before priming or painting fit the fender body braces and mounting points in place. Fender rivets hinge and brackets will have to be tweaked for final fitment. The left side fender relief plate is built in as part of the main fender body. Fender tail is not drilled or cut out for tail lamp installation. *NOTE: There are holes in the fender that will need to be filled. *NOTE: Optimal updated hinge is available for restorers who would like to replacehing on our fenders. *Note: UPS may consider this part as packaged inchoversize inch for shipment as compared to the actual weight which will result in higher shipping costs.

MEASUREMENTS

• Length: 33 inches
• Fender Width: 7-1/4 inches